Features:

• Thermocouple or RTD Input
• Heat/Cool Control Action
• User Programmable: Proportional or On/Off Control
• 4 Digit PT/ST Display
• 5 State PT Deviation Readout
• Accuracy: ± 0.25% Full Scale
• Sensor Input (order separately):
  Thermocouple (T/C) Type T, J, E, K
  Platinum RTD 100 ohms
• 20 Different Ranges Varying From -130°F to +1800°F or -90°C to +1200°C
• 1200W Load Capacity
  (higher power loads possible with optional Load Power Center I)

• LED 4-digit Display: Allows instant user choice of Process Temp (PT) or Set Temp (ST) by manual switch selection or exclusive automatic alternative action solid state switching of PT/ST display.
• Hysteresis Control: Allows adjustment of the control system cycle rate and on/off hysteresis, which is adjustable from 0.25% to 10% of full scale to maximum of 10°F.
• Bandwidth Control: Proportional models are adjustable from 0.5% to 20% of chosen full scale span.
• Power Output: Relay has conservative 10AMP heating and 10AMP cooling load. Higher power loads possible with optional Load Power Center I. Call us for higher power options.
• Setpoint Control: Exclusive circuit allows setpoint adjustment by 1 degree increments, or .1 degree increments in the high resolution mode.
• Deviation Indicator: Exclusive 5-state LED logic device provides selectable resolution of process deviation from set temp to 1%, 2%, or 4% of full scale.
• Recorder Output and Audible Alarm Options: Various options are available - call us directly for these options.
• Plug and Play Ready: Just plug in the probe and heater and you are ready to control your process.

The DynaSense^® MK III is a universal digital proportional or on/off temperature control which allows instant system setup. These controllers provide pinpoint accuracy of heating and cooling devices through the use of two position, on/off control action, operating alternately and independently with true proportional cooling algorithms. The temperature change of the input sensing devices is analyzed by an 8-bit microprocessor which controls a high current, electromechanical, two position relay in direct relation to system demand and deviation from the temperature setpoint. Typical control accuracy is ± 0.02°F. Indicating accuracy is ±0.25% full scale, ±1 digit.