Click Image to Enlarge

Features:

• Heat/Cool Control Action
• 4 Digit PT/ST Display
• Deadband Adjustable
• 2 Position On/Off control
• Accuracy: ±0.1% Full Scale
• Sensor Input: Platinum RTD-100ohms
• Ranges: -190°F to +1000°F or -190°C to 650°C
• 1200W Load Capacity
  (Higher power loads possible with optional Load Power Center I)
• Recorder Output Ma/MV
• Order Platinum RTD Probe separately under Temperature Probes

• LED 4-digit display: Allows instant user choice of Process Temp (PT) or Set Temp (ST) by manual switch selection or exclusive automatic alternative action solid state switching of PT/ST display.
• Recorder Output: Exclusive circuit design allows selection of 0-1MaFS for use with economical chart recorders or high accuracy 10MV/°F for use with potentiometric chart recorders.
• Deadband Control: Allows adjustment of the control system cycle rate and on/off hysteresis. The on to off differential is adjustable from 0.5degrees F to a maximum of 10 degrees F.
• Heat/Cool Power Indicators: These continuously monitor available 120VAC power at the Heat and cool plug-in AC power output receptacles.
• Power Output: Relay has conservative 10amp heating and 10amp cooling load rating for long life. Call us for higher power options.
• Setpoint Control: 15 turn potentiometer provides high accuracy and resolution of setpoint temperature adjustments.
• Plug and Play Ready: Just plug in the probe and heater and you are ready to control your process.

The DynaSense^® MK I is a digital, indicating, on/off temperature controller, which allows instant system setup and provides pinpoint accuracy with on/off control action of heating and cooling devices operating alternately and independently. The resistance vs. temperature change of the platinum RTD probe is amplified by a complex solid state assembly, which controls a rugged electromechanical, two position relay in direct relation to system demand and deviation from temperature setpoint. Indicating accuracy is ±0.1% full scale, ±1 digit. The unit provides a bistable output relay, which alternates the heat or cool device input to the temperature controlled system in response to the RTD sensor temperature and produces a classic sawtooth (on/off) type response curve at the setpoint temperature. An adjustable deadband control provides cycle rate and on/off differential adjustment.